Видео

Kösziii, mint a segítséget is 🥰

Köszönöm szépen!

Thanks, good luck with your 3s project!

Thanks! Have a lot of fun with it! 😃

Thanks! Yeah, I did the idle adjust with the butterfly's screw and positioning the throttle sensor

First time the idle wasn't set well, but after a little adjustments it works perfectly fine with the stock ECU

*sad intensifies, na majd ha sikerül kideríteni miért szar a fék.. 😂

Oh boy They will!

ur way 2 late, atleast where im at lol

@@carbxn432 costs 2k-5k in lithuania, though theyre pretty rare to find

@carbxn432 the yens value vs the usd has dropped a lot and I'm looking at importing one directly

3uz with a manual 30d shifter

oooh nice combo. still you managed to keep up with him, nice.@@BeKalolz

Almost 200hp with a pretty hot intake manifold, so it's performs around 168-170whp like yours I've got a custom "TRD" style 8,1kg flywheel, a "custom" cut air intake filter box and refurbished stock injectors, fully stock exhaust with cat. This year planning to get a fancy exhaust manifold and decat, install my Premium Japan throttle kit and Apexi Power FC to program a little better middle range performance.

@@BeKalolz I just got the premium throttle kit, was thinking if a standalone ecu was needed after the throttle kit conversion. Did the throttle kit change the performance of the mid range? cheers

@@jerometor392 hard to say without a new measurement, the response clearly better in the low/mid range, but I expected a bigger difference

Sorry, I forgot to reply, officially it should be 207hp, there are minimal modifications on it, I would have expected to perform within 2% loss

​@BeKalolz you do know they are never accurate with the advertised hp

​@@BeKalolzwhat fuel were you running it on? You probably need to run it on 100 octane to get quoted power for a start

@@BeKalolz with the age of altezza, 197hp is consider healthy.

@@junit7590 never used with lower octane than 100, heard throw a check engine if using with 95, so never tried trashy fuel :D

17x8 Advan AVS6

It's not awd ofc, my friend have that dyno, so that's I brought it here

@@BeKalolz oh OK 👌

Kliobesztvidejosautoafterdáktép

Mikor láttam hogy nincs vele bírás megkérdeztem és 1.3 8v, 700kg és 110Le. :D

Köszi!

Ki kell próbálni mindent is.. Kormányművet meg nem kell félteni, Toyota és van otthon másik belőle 😂

Köszii 🥰 Azért több meló ezt összerakni, meglátjuk van-e értelme 😀

Határozottan jó volt, gyere! 😀

@@BeKalolz Jövő szezonra talán az ikrek is már akkorák lesznek, hogy eltudok szabadulni 1 napra, illetve remélem lesz valami ütőképes autóm is. 😅

Hajrá!!! Gyere csak Apuka! :)@@lasi85

@@gaborlazar4646 😁

Köszönöm! Örülök, hogy jöttél és segítettél is 🥰

Yeah, I have shots about the refurbish, but don't have too much time to get it together, but planning to finish it this year!

😂😂😂

Altezza had optional Recaro SP-JJ seats, but these are from a JDM Evo8

Any pics of optional Recaro’s? I’ve never seen them

@@BusStopBoxer42 instagram.com/p/CA_ouOcHN01/

Köszii, de még mindig nem fordul rendesen, előlre kötelező valami értelmesebb gumit rakni, ezek csak hátra jók :D